Course description
Fees and charges
Equivalent Full Time Student Load (EFTSL)
EFTSL is the standard annual full time load. Eight credit points is the standard full time load for one year of study.
This is a fee-paying course. Domestic students may be eligible for FEE-HELP assistance in paying these tuition fees. For more information about FEE-HELP go to http://www.deakin.edu.au/future-students/fees/
Fee paying place - Domestic (DFP)
A Fee paying place is one for which the university does not receive any government funding. As such, students enrolled in these places are required to contribute the full cost of their course.
Fee paying places are available to domestic students. Domestic students are those who are Australian citizens, New Zealand citizens or holders of a permanent visa.
* The 'indicative annual course fee' cited has been provided as a guide only. It has been calculated on the basis of a typical enrolment of a student undertaking the course in 2009, and reflects the cost involved in undertaking a full-time quota of units within the specified discipline.
The actual fees charged by Deakin University will depend upon the discipline from which each individual unit is chosen, and may vary from the indicative course fee cited, particularly if units are chosen from a number of disciplines. The cost of each unit offered in 2009 can be viewed at http://www.deakin.edu.au/current-students/handbooks2009/search.php.
Please note that the fees per unit/credit point may increase annually due to rises in the cost of course delivery and service.
Deakin assumes no responsibility for persons relying on 'indicative course fees' to calculate the total future cost of their course.
Course rules
To be awarded the Graduate Diploma of Engineering, a student must successfully complete units with a total value of 8 credit points, including the following:
Two common core units from:
SEB711 Developing and Managing Innovation
SEN705 Engineering Professional Practice
SIT764 Project Management
and
At least four units from a specialism in one of:
Mechanical Engineering (Product Design and Development)
Mechanical Engineering (Automotive Engineering)
Electronics Engineering (Automation and Control Systems)
Electronics Engineering (Automotive Intelligent Systems)
Civil Engineering (Construction Management)
Civil Engineering (Water Engineering)
Equipment Requirements
Students must have access to the Internet, a microcomputer, modem and printer to provide, via the telephone network, communication with Deakin University's on-campus computers. Prospective students may wish to contact the School of Engineering and Information Technology to obtain information about the hardware and software requirements, telephone 03 5227 2536.
Admission requirements - general
Deakin University offers admission to postgraduate courses through a number of Admission categories.
In all categories of admission, selection is based primarily on academic merit as indicated by an applicant's previous academic record.
For more information on the Deakin Admissions Policy visit The Guide
Admission requirements - specific
The Graduate Diploma of Engineering can be undertaken as a stand alone course or exit qualification from the Master of Engineering or Master of Engineering (Professional) programs. Entry to the Graduate Diploma of Engineering requires a four-year Bachelor of Engineering degree or equivalent. Applicants without a Bachelor of Engineering degree entry qualification, who have been admitted to membership of Engineers Australia or other equivalent professional body, may be admitted to the program subject to Faculty Board approval.
Advanced standing - general
The University aims to provide students with as much credit as possible for approved prior study or informal learning which exceeds the normal entrance requirements for the course and is within the constraints of the course regulations. Students are required to complete a minimum of one-third of the course at Deakin University, or four credit points, whichever is the greater. In the case of certificates, including graduate certificates, a minimum of two credit points within the course must be completed at Deakin.
You can also refer to the Advanced Standing System which outlines the credit that may be granted towards a Deakin University degree.
Advanced standing - specific
Advanced standing may be granted for relevant postgraduate studies, in accordance with standard University rules.
How to apply
Applications must be made directly to the university through the Applicant Portal referring to closing dates for applications as dates for particular courses may vary.
Your faculty may require further information from you when submitting your application. Please refer to the faculty information website for further details.
